Kobelco / Field diagnosis / Start here
Most excavator faults are found by matching what the machine is doing to the right checks, not by guessing a part. This library organises 79 field guides into three paths: start with the symptom, start with the model, or look up a fault code.
Browse by symptom
Ten symptom families, from a machine that will not move to a single track that stopped.
Open symptom index →Path 02Browse by model
SK200-8, SK210-8, SK200-10, -8 and -10 series, Hino engines and larger -8 machines.
Open model index →Path 03Look up a fault code
22 code and alarm guides. Read every code together with the model and serial number.
Open code section →Browse by symptom
10 families / 63 guidesNo movement / machine dead
Check the safety lock circuit and pilot pressure before ordering a pump.
4 guides →02 / S2Slow or weak movement
If every function is slow at once, check pilot pressure and oil condition first.
5 guides →03 / S3Travel & final drive
Decide first whether the drive motor spins while the track stays still.
3 guides →04 / S4Hard start, stall & no rev
Separate fuel supply, SCV and speed sensor faults before replacing the pump.
6 guides →05 / S5Smoke, power loss, fuel & turbo
Record smoke colour, load and hour meter reading before pulling the turbo.
6 guides →06 / S6Overheating & cooling
Check the radiator cap and coolant return path before blaming the water pump.
4 guides →07 / S7Fault codes & alarms
Read every code together with the model and serial number; the same code can point to a different circuit.
22 guides →08 / S8Hydraulic oil, pressure, leaks & cylinders
Confirm oil level and pressure with a gauge before opening the valve block.
6 guides →09 / S9Electrical, sensors, solenoids & cab systems
Verify power and ground at the connector before swapping the sensor.
6 guides →10 / S10Swing, boom & attachment
Check the brake release circuit and the pilot line first.
1 guides →Featured case studies
Field diagnosis / step by stepNo fault code, no movement
A machine that will not move and shows no code: start with the beep test, then work through the safety lock circuit.
Read the case →Case study / S2 / M1All functions slow
Several valves sticking at once usually points back to the oil. Follow the checks and the clean-up sequence that stops it coming back.
Read the case →Case study / S3 / M2One track stopped
One side dead while everything else works: confirm the motor is spinning, then inspect the final drive coupling before replacing the motor.
Read the case →Reference library
16 guidesPanel functions, pin-outs, ABC adjustment, display language settings, filter kits and parts lists. Reference material rather than fault symptoms, filed in its own section of the symptom index.
Common questions
FAQDo I need a fault code before I start?
No. Several common faults produce no code at all. Start with what the machine is doing, then use the checks in the matching symptom section.
Are part numbers the same on -8 and -10 machines?
No. Always confirm the part number against your machine model and serial number before ordering. Hydraulic and electrical settings also differ between series.
Can I use these checks on other brands?
This library covers Kobelco machines and Hino engines. Guides for Caterpillar and Komatsu are filed separately and should not be used as Kobelco references.
What should I include when I ask for help?
Send the model, serial number, hour meter reading, the symptom, any fault code, and what you have already checked. A short video of the fault helps as well.
Not sure which path fits?
Tell us the model, serial number and what the machine is doing. Include any fault code and the checks you have already tried.


